Concrete vibrator experts - Strong vibrator Anyang City Public Co., Ltd. 1, must be checked before use, the direction of rotation should be consistent with the labeled directions; connecting all parts are tightened, the damping device is good, only after making sure that good after use. 2, when the power supply line through the road, should the overhead or floor tank, must be added to the cover to protect the slot provided. 3, the use of plug-in vibrators person, one person, another person with the master motor and switch. The hose connecting the motor must be firm, HTC vibration motor purchase, bending radius of the hose must not be less than 50 cm, so as not to break, and no more than two bends. In operation, the vibrators should sink naturally vertically man seized the trombone can not be too much force when, as found in the hose leakage, immediately turn off the power for maintenance. 4, when the rainy day operations, vibrators motor apparatus should be rain. When used to pay attention to the hose connector rod shell must be sealed to prevent water slurry invasion. 5, power brake box, from the actual place of operation, as far as not more than 3 meters. The breaker box if special care must concentrate, timely and accurate transmission according to the command signal. 6, insert vibrators in reinforced vibrated online face, you should pay attention not reinforced grip vibrator or a hard object hitting the rod body and damage. Also, pay attention to wire insulation, if found leakage or zero line off the motor should be repaired promptly cut off the power. 7, at work, price HTC vibration motor, vibration rods can not be inserted too deep, stick the tail to be exposed 1 / 3-1 / 4 is appropriate. Do not insert concrete shaft portion. 8, in operation, each vibration time can levy slump decision, HTC vibration motor company, off of the smaller, the longer the vibration. 9, in the winter construction, when as a result of the condensation of oil lubricants and difficult start, Zhanjiang HTC vibration motor, available water slow charcoal grilled vibrator, but not with fire roasted or wash water hot. 10, with a plate vibrator hove, the rope must be insulated and dry. 'They should cooperate closely and steering movement, should not be dragged tied at both ends of the plate on the motor. 11, connecting bolts vibrators and electrode, should always be fastened, the introduction of vibrators power lines should be fixed on the plate, electrical switches should be mounted on the handle in order to open and close. 12, when moved in operation shall be such that the wires of the motor to maintain a sufficient length and looseness, rendering it taut. Avoid thread pulled off. 13, the outer surface of the vibrators should be kept clean and the water slurry adhered to the motor housing, so as not to interfere with the motor cooling. 14, when operating vibrators, motor temperature must not exceed 75 degrees, cool down, if necessary, to identify obstacles in operation, should immediately stop excluded.